The sensor charging cable is worn broken.
Owlet sock sensor not charging.
On the front there is a logo and on the side are two micro usb port to charge the base station and to charge the sock sensor.
If the lights will not turn off use a refrigerator or similar magnet dragging it across the bottom of the electronics dome.
It is a little frustrating to not have a sense how much the sock is charged besides it being fully done and no longer blinking green.
Charge at least every day.
The sensor charging cable needs to be replaced.
Get an 8 hour charge in under 20 minutes and a full 16 hours in 90 minutes.
How to charge the smart sock.
You may continue to have blue notifications and will not be able to get reads if your smart sock battery is dead or dying.
Takes approximately 3 4 hours until full charge.
There are four possible reasons why your sensor is not charging.
These four reasons are.
Please note that this is not a type c micro usb port.
The owlet app will not display the charge amount while the sock is plugged in and charging.
The base station is not accepting a.
The owlet smart sock is a consumer product that provides parents insights into their baby s wellness as well as peace of mind each time the parent puts their child down for a nap or to sleep at night.
All it s says in the menu option is that it is charging.
The owlet smart sock is not a fda approved medical device and is designed and intended for families with healthy infants.
Open the owlet app and check the smart sock battery gauge under settings in the lower left corner.
A base station receives the signal from the smart sensor device that gets attached to the socks.
Examples of poor sock fit.
The sensor is the white electronic inside the fabric sock and shown in the picture below.
The base station receives information from the owlet s pulse readings.
Below we will review all four reasons.
It also monitors babies through gentle motion so you get live readings more often.
Once the lights have turned off wait 60 seconds and then plug the smart sock electronics back into the base.
If your goal is to turn the electronics off stop here.
Monitor what matters most.
Charge the sock battery by plugging the sensor into the base station and the base station into an electrical socket.
Battery lasts approximately 18 hours this can vary depending on the physiology of your child.
Reset turn off the smart sock.
Sock plugged in sock in use not charging if needed re charge the smart sock.
Pairing your new sock.
With these changes the sock now fits babies both bigger and smaller from 5 lbs.
Track your baby s heart rate oxygen levels and sleep all while streaming live video.
